ADAS Laser Squares
Small little helpful square for lining up lasers for ADAS calibrations if you don’t have a 5 line laser. Each divit is a 90 degree angle. Holes cut out in the bottom to put a tire sticky weights if you want the square to be heavier. Hole in the middle is sized to allow a sharpie to create a center dot.
60mm x 60mm x 7.5mm
19.5mm x 16.5mm are the wheel weights you want to insert.
Comes in a pack of 4 (no wheel weights included)
Small little helpful square for lining up lasers for ADAS calibrations if you don’t have a 5 line laser. Each divit is a 90 degree angle. Holes cut out in the bottom to put a tire sticky weights if you want the square to be heavier. Hole in the middle is sized to allow a sharpie to create a center dot.
60mm x 60mm x 7.5mm
19.5mm x 16.5mm are the wheel weights you want to insert.
Comes in a pack of 4 (no wheel weights included)
Small little helpful square for lining up lasers for ADAS calibrations if you don’t have a 5 line laser. Each divit is a 90 degree angle. Holes cut out in the bottom to put a tire sticky weights if you want the square to be heavier. Hole in the middle is sized to allow a sharpie to create a center dot.
60mm x 60mm x 7.5mm
19.5mm x 16.5mm are the wheel weights you want to insert.
Comes in a pack of 4 (no wheel weights included)
