Nissan VI3 VCI Clasp
Smaller based VCI holder allows the mount to be attached to the VCI all the time. This design allows the VCI to be it’s own mount! With it’s included bungie you can lock down the cable during storage or hang it while you are using it. The mount is pre-drilled for an optional magnet kit along with 1 inch spacing pilot holes if you would like to mount it to a pegboard. Even if mounted permanently the VCI can still snap in and out! Fits the new Nissan VI3 VCI
Smaller based VCI holder allows the mount to be attached to the VCI all the time. This design allows the VCI to be it’s own mount! With it’s included bungie you can lock down the cable during storage or hang it while you are using it. The mount is pre-drilled for an optional magnet kit along with 1 inch spacing pilot holes if you would like to mount it to a pegboard. Even if mounted permanently the VCI can still snap in and out! Fits the new Nissan VI3 VCI
Smaller based VCI holder allows the mount to be attached to the VCI all the time. This design allows the VCI to be it’s own mount! With it’s included bungie you can lock down the cable during storage or hang it while you are using it. The mount is pre-drilled for an optional magnet kit along with 1 inch spacing pilot holes if you would like to mount it to a pegboard. Even if mounted permanently the VCI can still snap in and out! Fits the new Nissan VI3 VCI
Magnets and paint
If you purchase the magnet kit please take care if you are attaching it to a body of a car. The rubber magnets themselves should not scratch, but be aware that magnets can attract metal shavings and so on. …..So like don’t slap it against a door with a 10mm nut stuck to it. On one hand you have found your 10mm nut that you dropped, the second…you just scratched a vehicle.
Made in the USA shockcord provided. If you plan on replacing the shockcord the size is 3.5mm / .15in shockcord. When you find the right length and tie the knots flush cut and then slightly braise the end and put pressure with something to lock in the knot.
“transparent red” color is situational in the right light it is slightly but you will only really get the benifits with some of my thinner products like the amp clamp holders. Transparent red is more of a sparkly red
Made with PETG and should hold up very well in hot enviroments but I cannot always guarantee that. I’ve tested my holders and clasps in a 100 degree car with no issues of warping. Results may vary in super hot climates.
